The Chopper Compendium

Sweeet !!!

I used this .... hope you don't mind .... I look at the Jesse James FB page where he show a red chunk of metal he beats on and old anvil or an old power hammer ... anf then shows a beautiful machined pistol that he ask $4000 for and it is a basic 1911 .... there is so much butt sucking it make you s...

Wish you still did the seal kits ... hint

What did this pertain to .... I might have it ...?

Does anyone have to old list or the old post from the Fatso thread ????

If you flipped the trans, did you flip the engine also, make an adapter plate ...... ?

To busy building cars .... I will send to Nathan if he wants and he can sort out what works ... It is info that has been collected over years of building street rods and customs ....

Do you want all my stuff on flamethrowers .... ?

Tat .... I drill the holes and cut slits to the hole that makes 4 slots with no stress risers . Tube is then beveled and welded to the joint, then welded all the way around, after tacks are made at the slots to stop pulling .... might not have been clear ... been a while since this post ... ; ))

This tape is 2 " wide thin aluminum with glue to seal metal duct and aluminum faced fiber board... there are 2 thicknesses one blue, one red ...? .... not sure which is which, but makes a good shim that sticks in place ..... used by "bondo" shops the back up rust holes before the bond...

I have a pen knife that my unk used to scrape babbit bearing in his Model A ... this cutter was cheap and if it last to make a couple of sets, was worth it .... I just need a pinch fit ..... the aluminum duct tape will keep from scratching the chrome.... bought some black Rit dye, to anodize them bl...

I was wrong ,,,,, Yeah, it happens ... ; ) Was in Hongkong and he showed me the 39mm and It will be here in a couple of weeks.... I will layout , cut the caps and drill and tap holes and center a guide hole. Drill press vise will hold 2 at a time. Cut final P shape after all other work is done, leav...

Well, that's out , unless you want to send me a free one ..... was in the UK !! Found a 40mm and will use aluminum tape for ac ducts to shim... It is just to mount a windshield.

No ....... but they will be shaped like a "P", 39 mm holes, split and drilled and tapped to fit to 39mm legs. The leg part will stick out to the side and be drilled and tapped for button-head hex machine screws. I can draw up something. To keep them from being so bulky, 1/4-20 or smaller,...

In adding specs, I realized that this was more involved than it needs to be ..... thanks anyway.... bought this http://www.ebay.com/itm/Carbide-Tip-Metal-Cutter-Hole-Saw-Select-from-15-to-39mm-/140791782205 and will cut plate with carbide saw and drill and tap , cut cap and then use cutters to make ...