motorlou

The general bullshit and chatty section where we post general gossip.
Post Reply
friday
Tourist
Posts: 37
Joined: Sat Sep 27, 2014 5:08 pm
SELF INTRODUCTION: from jockey journal via NZ . got a shovelhead and a early scout project , planning on a mild custom from ground up = NO cutting only minimising and poss hotting up , so not a butcher here nor a 100 pointer! cheers willy

motorlou

Post by friday »

anyone know of this guy ?

I joined the horse forum , which has changed and seems to have dwindled .

theres a guy "motorlou" who started a thread on a build but hes gone quiet before I showed up .....
he plans on building an OHV V2 motor using citroen heads and cylinders :popcorn:

anyone seen trace of this build some where . face book is a night mare but Id go there if I knew where to look
Top
Brandundee
NewB
Posts: 3
Joined: Thu Jan 31, 2019 6:54 pm
SELF INTRODUCTION: Desk Jockey and paper cut survivor. I know my way around a Manuel Lathe/Mill & Grinders just a little. Also know a little Autocad and Solidworks.

Current Bike- 91 FXR

Previous Bikes- Cone Shovel Chopper, IH Chopper

Project- 57' Straight Leg

Re: motorlou

Post by Brandundee »

Hey Friday,
I believe I know the guy. I bought a part off him a few years back in Riverside Ca. You could probably check out CC Forum I know he tinkered on there when I use to go on there. If you need to get in contact with him directly you can send me a DM.
~B
Top
Post Reply

Return to “The Bull Pen”