Page 2 of 5
Re: new project
Posted: Mon Dec 19, 2022 4:38 pm
by Fossil
looking good Curt
Re: new project
Posted: Mon Dec 19, 2022 9:48 pm
by curt
thank you
Re: new project
Posted: Tue Dec 20, 2022 8:16 pm
by Maz
That all looks super cool dude, keep updating the pics please......
Re: new project
Posted: Thu Dec 22, 2022 5:55 pm
by curt
i will maz .
- SANY0204.JPG (341.51 KiB) Viewed 12203 times
- SANY0205.JPG (337.81 KiB) Viewed 12203 times
- SANY0207.JPG (320.47 KiB) Viewed 12203 times
had a little time today bent up the lower rails to the backbone . im not going to bend the rails up to the rear till i get the notches finalized to the backbone so that will be a little while . i never made one that went to the backbone before 3 tubes coming together at one spot with all the angles. got the motor mounts set to the seat post now i got to get the height set and the top wishbone tubes cut to length and sliced for the axl plates.
Re: new project
Posted: Thu Dec 22, 2022 9:27 pm
by Jeff L
moving right along Curt...
Re: new project
Posted: Mon Dec 26, 2022 5:27 pm
by curt
Re: new project
Posted: Tue Dec 27, 2022 8:29 pm
by budoka
dude! i let life make me step away for a moment, and I come back and you've got all THIS done. makes my heart glad to see! keep it up man, this stuff is like drugs to us!
-dan
Re: new project
Posted: Tue Dec 27, 2022 10:36 pm
by curt
it is dan it was easier quittin smokin
Re: new project
Posted: Thu Dec 29, 2022 4:40 pm
by curt
Re: new project
Posted: Fri Dec 30, 2022 9:24 am
by budoka
that rotation on the final bend has been the demise of many a piece of tubing! i have no doubt whatsoever that you'll nail it, though. just sucks you have to take a pause.
-dan
Re: new project
Posted: Fri Dec 30, 2022 12:59 pm
by curt
ya sucks but learned the hard way what i was doing wrong and ill keep the pieces and make something else out of them
Re: new project
Posted: Fri Dec 30, 2022 3:11 pm
by drivermark
That is one hella beefy duty notcher ya got there Curt. I like
Re: new project
Posted: Fri Dec 30, 2022 10:03 pm
by curt
drivermark wrote: ↑Fri Dec 30, 2022 3:11 pm
That is one hella beefy duty notcher ya got there Curt. I like Baliegh tn250 super ridgid can cut offset and on a bend and over 180 degrees great for roll cages stupid nice for most all bike stuff but a pain to get setup going back to an even cut from an offset . i added a bolt to help and it would be nice if there were some common stops for like 90 , 45 and such
Re: new project
Posted: Fri Dec 30, 2022 10:11 pm
by curt
- 2842[344].jpeg (437.24 KiB) Viewed 12170 times
id like to thank drivermark for making these for me stand up guy who went above and beyond for me and i really appreciate it
Re: new project
Posted: Sat Dec 31, 2022 12:41 pm
by Jeff L
Definitely some nice looking parts he made