bending tutorial videos

This section is for all posts concerning frame design and construction.
Post Reply
krymis
Conventioneer
Posts: 277
Joined: Sun Nov 06, 2011 12:46 pm
SELF INTRODUCTION: Hey dan it chris (krymis) from the CBH board. thanks for opening this back up. hope to have a project to show the build here. BLAH BLAH BLAH BLAH BLAH and so on and so forth. The book of revolations and worlds ends and shit like that.....

bending tutorial videos

Post by krymis »

old videos of a bending tutorial i did. i hope to do some new ones as i have improved on my lighting, cameras, and editing.



hansgoudzwaard
Contributor
Posts: 804
Joined: Wed Oct 26, 2011 10:43 pm
SELF INTRODUCTION: I was on the last board as bonustoolkit. I have changed that to my given name.
I started a project build there " File and Fit." I paln to continue that when I go back home in Dec. 2011. I first joined the board when Gary W had it in the year 2005. That was the time I really gained an interest in building chops. I have a long way to go, compared to some here.

Re: bending tutorial videos

Post by hansgoudzwaard »

Thanks for posting the videos. I can see the benefit of doing it on the horizontal. I set my frame tubes up on the floor on a centreline as Gary did, and that worked well for tacking, etc.
Post Reply

Return to “Frame Fabrication”