little video for seat rail

This section is for all posts concerning frame design and construction.
Post Reply
krymis
Conventioneer
Posts: 277
Joined: Sun Nov 06, 2011 12:46 pm
SELF INTRODUCTION: Hey dan it chris (krymis) from the CBH board. thanks for opening this back up. hope to have a project to show the build here. BLAH BLAH BLAH BLAH BLAH and so on and so forth. The book of revolations and worlds ends and shit like that.....

little video for seat rail

Post by krymis »

here is a little video i did for a client. walked him through what i was doing to create the bend sheets for his one off frame. Its a 140mm rear, sporty powered, Dominator style frame.



Image
Image[/QUOTE]
40' of 1.25"x .120 wall DOM on a 96 f150 doesn't work
Image
Post Reply

Return to “Frame Fabrication”