Question about radius, dies, and money

Use this section for posts concerning tools and equipment like benders and notchers for example.
User avatar
gww25
Site Grandaddy
Posts: 219
Joined: Thu Nov 24, 2011 2:45 pm
SELF INTRODUCTION: I'm just an old chopper builders who still dabbles in the craft and I hope that I can contribute something to the discussions as time goes by. Most of you already know that I started the Chopper Builders Handbook site so you're probably already familiar with my philosophy on choppers and chopper work.
Location: Murphy, Texas
Contact:

Re: Question about radius, dies, and money

Post by gww25 »

Yeah, the 6.5" is supposed to be measured to the main pin pivot hole center and the other hole dimensions are correct at 6". sorry about that but I guess most people catch it and don't bother reporting it. I'm working on new design that looks more like a pro-tools 105 but it can be mounted horizontally or vertically and be manual or air/hydraulic. I still go back to this old model whenever I need to do just a few custom bends in a hurry. I prefer the horizontal manual for frame work but I prefer the vertically model for bars and Girders.
Post Reply

Return to “Tools and Equipment”