another tool you really have to have to balance your flywheels (or your tires and wheels, for that matter), is a balancing jig. you also need a truing stand of some sort for truing your crank assembly. here's how you can make one tool to do both.
you start with some 3 or 4 inch square tubing. i cut 2 pieces 16" long, 1 piece 19" long, and 2 pieces about 15" long, then bevelled and cleaned up the edges for welding.
to be continued…
-dan
Balancing jig/truing stand
- budoka
- Site Admin
- Posts: 492
- Joined: Thu Jul 21, 2011 12:51 pm
- SELF INTRODUCTION: I'm a Kentucky boy who's found himself transplanted into Japan. been into turning wrenches as long as i can remember. i love muscle cars, hotrod bikes, and the martial arts.
been a member of this board since back when it was a part of Chopperweb. been handling the tech side and sharing the admin duties for several years now. - Location: Fuefuki Shi, Japan
- Contact:
Balancing jig/truing stand
- Attachments
-
- tools_16022.jpg (65.9 KiB) Viewed 4514 times
-experience is a wonderful thing. It enables you to recognize a mistake when you make it again.
http://knuckleheadsummer.blogspot.com/
http://knuckleheadsummer.blogspot.com/
- budoka
- Site Admin
- Posts: 492
- Joined: Thu Jul 21, 2011 12:51 pm
- SELF INTRODUCTION: I'm a Kentucky boy who's found himself transplanted into Japan. been into turning wrenches as long as i can remember. i love muscle cars, hotrod bikes, and the martial arts.
been a member of this board since back when it was a part of Chopperweb. been handling the tech side and sharing the admin duties for several years now. - Location: Fuefuki Shi, Japan
- Contact:
Re: Balancing jig/truing stand
next, i welded the two upright pieces (the 16" long pieces) to the bottom piece (the 19" piece) to form a U shape.
then i welded some nuts in the 15" pieces i'll use for the feet,
and then welded the feet to the bottom of the U shaped piece, welded in some threaded bungs, and some gussets for strength.
add some skateboard bearings and of course a little paint to spruce it up, and we're all ready to use it.
then i welded some nuts in the 15" pieces i'll use for the feet,
and then welded the feet to the bottom of the U shaped piece, welded in some threaded bungs, and some gussets for strength.
add some skateboard bearings and of course a little paint to spruce it up, and we're all ready to use it.
-experience is a wonderful thing. It enables you to recognize a mistake when you make it again.
http://knuckleheadsummer.blogspot.com/
http://knuckleheadsummer.blogspot.com/
- curt
- Long in the Tooth
- Posts: 1068
- Joined: Tue Oct 25, 2011 11:36 am
- SELF INTRODUCTION: hi everyone its me from the old bord hopeing to see everyone come here and all the newcomers . lets make this as good as the old one or even better . lookin foreward to seeing everyones projects continue and ill be continueing mine too
- Location: utica new york
Re: Balancing jig/truing stand
nice
ever notice when you hit somethin or someone with a hammer you feel instantly better