Page 1 of 1
neck cups
Posted: Tue Feb 07, 2012 8:02 pm
by Tim B 1640
not sure if i'm in the right area but i'm going to ask anyway. i'm going to machine a set of neck cups out of stainless and i was looking at the drawing that is in the download section and my question is are the measurements that are shown in the drawing for neck cups or for the bearing races ? thanks
Re: neck cups
Posted: Tue Feb 07, 2012 10:09 pm
by jimmib
As it says, "NECKNOCUPS". The drawing is for a complete neck to install just the bearing races. The Timken bearing (cone) and race (cup) numbers are on the drawings. I would get your races, measure O.D. and machine for press fit. Usually around .005". Although this may vary some depending on bearing manufactuer.
Jim
Re: neck cups
Posted: Wed Feb 08, 2012 7:03 am
by Tim B 1640
thanks for the help