The Chopper Compendium

in the jig section i posted about building a motor mount fixture and template for an iron head. well attached are the finished photos of the frame

This turned out really nice, and I think, pretty darn original as well.

now THAT is sweet!

-dan

Awesome.

That tubing arrangement on the rear section is unusual too me, looks really strong.

bob that setup is actually the weak setup. he should have ran the from the seat post back to the axle plate then added in the vertical tube. he has the top of the axle block and tube now pushing a short length of tubing horizontally into the vertical tube. it will work but i would have rather he did it another way.

good point about the stresses from the axle plate going into the other tubing.
I took a second look, and you're right.