The Chopper Compendium

Found this link in a DIY section, making pushrods to your custom length...

http://aircooledtech.com/custom_push_rods/

Then went to the supplier and found this,
http://www.cbperformance.com/catalog.as ... tID=1243is link...

Chromoly with dimensions. I didn't compare to HD rods. but if you don't like adjustable rods, you might give these consideration.
8 to a set for $155, enough for 2 HD evo motors. Some high performance motors are very hard on adjustable pushrods.
I know I've bent some in the past.

Thanks R'Bob.

This......I can use immediately.

http://aircooledtech.com/tools-on-the-c ... ing_beads/

andy....

hansgoudzwaard wrote:Thanks R'Bob.

This......I can use immediately.

http://aircooledtech.com/tools-on-the-c ... ing_beads/

You might do research on this. It sounds good, but I've seen posts on the motocy forum on craigslist
that were not favorable.

The concept sounds reasonable tho.

hansgoudzwaard wrote:Thanks R'Bob.

RRB is easier.....