UL Jug Reclaim
Posted: Sun Mar 01, 2015 10:40 pm
Well, once again I seemed to have got another oldie in super sad shape to rebuild.
This one is a 1937 UL;
Thought I would start at the top and work my way down.
Here's what I had to work with... Mostly rust from 30 years of sitting....
First off was a wash up ...Then a blast.
[URL=http://s279.photobucket.com/user/d ... .jpg[/img][/url]
New valve parts went down...
[URL=http://s279.photobucket.com/user/d ... .jpg[/img][/url]
A set of sleeve was ordered....
[URL=http://s279.photobucket.com/user/d ... .jpg[/img][/url]
Some boring, leavening .003 for a press fit.
Bore was out to .060 over and had way to much rust to go even to max. oversize...
[URL=http://s279.photobucket.com/user/d ... .jpg[/img][/url]
And a few deep dings...
[URL=http://s279.photobucket.com/user/d ... .jpg[/img][/url]
Heat the jugs to 450 degrees and push them in to their new home...
[URL=http://s279.photobucket.com/user/d ... .jpg[/img][/url]
Some more boring and done deal.
[url][/url]
[URL=http://s279.photobucket.com/user/d ... .jpg[/img][/url]
Next on down the list will be taking a hard look at some more rust in the cam area of the motor....
This one is a 1937 UL;
Thought I would start at the top and work my way down.
Here's what I had to work with... Mostly rust from 30 years of sitting....
First off was a wash up ...Then a blast.
[URL=http://s279.photobucket.com/user/d ... .jpg[/img][/url]
New valve parts went down...
[URL=http://s279.photobucket.com/user/d ... .jpg[/img][/url]
A set of sleeve was ordered....
[URL=http://s279.photobucket.com/user/d ... .jpg[/img][/url]
Some boring, leavening .003 for a press fit.
Bore was out to .060 over and had way to much rust to go even to max. oversize...
[URL=http://s279.photobucket.com/user/d ... .jpg[/img][/url]
And a few deep dings...
[URL=http://s279.photobucket.com/user/d ... .jpg[/img][/url]
Heat the jugs to 450 degrees and push them in to their new home...
[URL=http://s279.photobucket.com/user/d ... .jpg[/img][/url]
Some more boring and done deal.
[url][/url]
[URL=http://s279.photobucket.com/user/d ... .jpg[/img][/url]
Next on down the list will be taking a hard look at some more rust in the cam area of the motor....