Page 2 of 2
Re: INSTALL A OPEN PRIMARY BELT DRIVE.....
Posted: Tue May 24, 2016 12:23 pm
by hansgoudzwaard
Good oil pressure, and was an easy start.
https://vimeo.com/167203546
I have pulled it apart to get on with the rest of this build.
Re: INSTALL A OPEN PRIMARY BELT DRIVE.....
Posted: Thu Jul 28, 2016 3:19 pm
by hansgoudzwaard
- TranyHub.JPG (150.22 KiB) Viewed 6085 times
Determined that the belt drive would not work in the 140 frame.
The transmission came with a belt drive hub/sprocket.
Took it off yesterday, and am ordering a chain steup for this bike.
Had to remove the inner primary, but left all else in place.
I will use a 51 tooth rear sprocket I borrowed for mockup to set up the chain drive.
Re: INSTALL A OPEN PRIMARY BELT DRIVE.....
Posted: Sun Jul 31, 2016 9:24 am
by Jim Sawyer
I used a chain on my build as well. definitely no room for a belt on mine either
Re: INSTALL A OPEN PRIMARY BELT DRIVE.....
Posted: Mon Aug 01, 2016 11:57 am
by hansgoudzwaard
Jim Sawyer wrote:I used a chain on my build as well. definitely no room for a belt on mine either
Did you use HD parts ; what size is your rear tire?
Re: INSTALL A OPEN PRIMARY BELT DRIVE.....
Posted: Sun Sep 10, 2017 8:46 am
by Jim Sawyer
I used a 1/2" offset front sprocket, and a stock HD flat rear sprocket . The offset sprocket is made by PBI
Re: INSTALL A OPEN PRIMARY BELT DRIVE.....
Posted: Sun Sep 10, 2017 8:48 am
by Jim Sawyer
This chart shows some of their options
Re: INSTALL A OPEN PRIMARY BELT DRIVE.....
Posted: Mon Sep 11, 2017 11:40 pm
by hansgoudzwaard
Jim Sawyer wrote: ↑Sun Sep 10, 2017 8:46 am
I used a 1/2" offset front sprocket, and a stock HD flat rear sprocket . The offset sprocket is made by PBI
Thanks Jim, I got front and rear from PBI. Nice product.