Penetrating Oils
Posted: Tue Jan 29, 2013 2:57 am
Received this in an email today, so...
Caveat Emptor
__________________________
Subject: Penetrating Oils - FYI
>>>> Machinist's Workshop Mag recently published some information on
>>>> various penetrating oils that was very interesting. Some of you might
>>>> appreciate this. The magazine reports they tested penetrates for break
>>>> out torque on rusted nuts. They are below, as forwarded by an
>>>> ex-student and professional machinist. They arranged a subjective test
>>>> of all the popular penetrates with the control being the torque
>>>> required to remove the nut from a "scientifically rusted" environment.
>>
>>>> *Penetrating oils .......... Average torque load to loosen*
>>
>>>> No Oil used ................... 516 pounds
>>>>
>>>> WD-40 .......................... 238 pounds
>>>>
>>>> PB Blaster ..................... 214 pounds
>>>>
>>>> Liquid Wrench ...............127 pounds
>>>>
>>>> Kano Kroil .................... 106 pounds
>>>>
>>>> ATF*-Acetone mix...........53 pounds
>>>>
>>>> The ATF-Acetone mix is a "home brew" mix of 50 - 50 automatic
>>>> transmission fluid and acetone. Note this "home brew" released bolts
>>>> better than any commercial product in this one particular test. Our
>>>> local machinist group mixed up a batch and we all now use it with
>>>> equally good results. Note also that "Liquid Wrench" is almost as good
>>>> as "Kroil" for about 20% of the price. Steve from Godwin-Singer says
>>>> that ATF-Acetone mix is best, but you can also use ATF and lacquer
>>>> thinner in a 50-50 mix. *ATF=Automatic Transmission Fluid
Caveat Emptor
__________________________
Subject: Penetrating Oils - FYI
>>>> Machinist's Workshop Mag recently published some information on
>>>> various penetrating oils that was very interesting. Some of you might
>>>> appreciate this. The magazine reports they tested penetrates for break
>>>> out torque on rusted nuts. They are below, as forwarded by an
>>>> ex-student and professional machinist. They arranged a subjective test
>>>> of all the popular penetrates with the control being the torque
>>>> required to remove the nut from a "scientifically rusted" environment.
>>
>>>> *Penetrating oils .......... Average torque load to loosen*
>>
>>>> No Oil used ................... 516 pounds
>>>>
>>>> WD-40 .......................... 238 pounds
>>>>
>>>> PB Blaster ..................... 214 pounds
>>>>
>>>> Liquid Wrench ...............127 pounds
>>>>
>>>> Kano Kroil .................... 106 pounds
>>>>
>>>> ATF*-Acetone mix...........53 pounds
>>>>
>>>> The ATF-Acetone mix is a "home brew" mix of 50 - 50 automatic
>>>> transmission fluid and acetone. Note this "home brew" released bolts
>>>> better than any commercial product in this one particular test. Our
>>>> local machinist group mixed up a batch and we all now use it with
>>>> equally good results. Note also that "Liquid Wrench" is almost as good
>>>> as "Kroil" for about 20% of the price. Steve from Godwin-Singer says
>>>> that ATF-Acetone mix is best, but you can also use ATF and lacquer
>>>> thinner in a 50-50 mix. *ATF=Automatic Transmission Fluid