Elegant spring leg clevis

Try using this area for frontend information.
Post Reply
krymis
Conventioneer
Posts: 277
Joined: Sun Nov 06, 2011 12:46 pm
SELF INTRODUCTION: Hey dan it chris (krymis) from the CBH board. thanks for opening this back up. hope to have a project to show the build here. BLAH BLAH BLAH BLAH BLAH and so on and so forth. The book of revolations and worlds ends and shit like that.....

Elegant spring leg clevis

Post by krymis »

I am going to post how you can make a simple yet elegant spring leg clevis. I start off with a 5/8" solid rod spring leg. My springer uses 1/2x13 shoulder bolts just like Denvers and sugar bear. the clevis tapers out from 3/4" to 1". The tab itself is 1/2" thick and to make a nice looking bottom cap i use sharpe industries steel tube caps.
gearhead1951
Builder
Posts: 367
Joined: Wed Oct 26, 2011 4:49 am
SELF INTRODUCTION: I am an expat tennessee hillbilly and retired us navy engineer livin' in Scotland and I have a love of old cars , trucks, motorcycles and most any other machinery !

I dont know if I can think of enough to say to reach the two hundred charactor minimun set by the mods , but I will persevere
Location: Greenock Scotland

Re: Elegant spring leg clevis

Post by gearhead1951 »

No pics , didn't happen ! (sounds like an excellent idea , would love to see it !)
Post Reply

Return to “Springers, Girders, Spirders and Leafers”