The Chopper Compendium

OK I have a Donnie Smith girder and it needs a fairly narrow hub to date I have only found the HD hub to be 4.5-4.75" wide is there a 4" wide hub out there ?
I am also using a 3/4" axle

try bitter end choppers

railroad bob wrote:http://www.donniesmith.com/

Yeah I talked to Donnie, ( nice helpful guy) said that after cci bought the rights to the girder it was a mixed bag after that and the measurements were all over the place. So what I did (the answer) is I used a dyna front 21"wheel had a custom machined axle made ($50) and it fits like a glove. still there is a brake clearance issue but it think I can just fab up a custom caliper mount and be done with it. UNLESSS there is an offset 10.5"rotor for a hd out there somewhere in the eather........ Thanks for all the replies !!!!!!!!!