Disk braken material?

This is for posts and questions about the above subjects.
Post Reply
joey3380
NewB
Posts: 2
Joined: Sun Jan 29, 2012 10:10 am
SELF INTRODUCTION: I'm from the netherlands, 31 years old, a passion for custom build bike's.
I have build one bike my self, a late shovel style bobber.
i want to build a new bike, a fat tank low longbike.
ik like to share my ideas and pick up some.
i use to be a member of this forum but for some reason i can not log in annymore so i re-do my registration.
Location: Netherlands

Disk braken material?

Post by joey3380 »

What kind of stainless steel can I use for disc brakes ?
User avatar
gww25
Site Grandaddy
Posts: 219
Joined: Thu Nov 24, 2011 2:45 pm
SELF INTRODUCTION: I'm just an old chopper builders who still dabbles in the craft and I hope that I can contribute something to the discussions as time goes by. Most of you already know that I started the Chopper Builders Handbook site so you're probably already familiar with my philosophy on choppers and chopper work.
Location: Murphy, Texas
Contact:

Re: Disk braken material?

Post by gww25 »

I've seen people making them from both 316 and 304 and even a few outfits using cold rolled steel and then plating it so I'm not to sure if the material is all that important except in perhaps some kind of high performance application. If I was going to make some rotors I'd use 316 since it's relatively easy to find and takes a nice finish after it's been surface ground.
Post Reply

Return to “Wheels, Tires, Sprockets, Belts, Chains and Brakes”