Page 1 of 1

Magneto Resource

Posted: Sun Jan 26, 2014 1:54 am
by railroad bob
Found a guy in Texas that rebuilds magnetos, sells parts. His focus is industrial and welders, but he has a lot of the common manuf represented, Fairbanks-Morse, etc. Might be a possible source for rebuilding something you have already, or finding one you are looking for, or even just getting some measurements and advice.

There was a thread on AWS that he advertised in.
Here is a link to the thread...
http://www.aws.org/cgi-bin/mwf/topic_show.pl?tid=32672

and here is the message that was posted...

Rebuilt & new magnetos sold outright, exchange or repair yours. American Bosch, Fairbanks Morse, Wico, Bendix industrial, Slick industrial & others for welder engines Continental, Hercules & Waukesha 4 & 6 cylinder. 1, 2 & 4 cyld mags for Wisconsin engines. Prices depend on how many new parts needed & labor involved. Tested & rebuilt with special tools & test equipment no guessing. Magnets recharged & thrust bearings set to dial indicator factory standards. Stock & prices change constantly. Many other mags 1 to 8 cylinder industrial & tractor engines of all kinds. Oil field engine magnetos, electronic conversion kits & NOS parts that can't be found I may have or can get them. Carburetor repairs, New carbs, new Wico & FM mags, spark plugs, stock or custom spark plug wires, custom made battery cables, switches, new electronic distributors, electronic modules, regular or shielded ignition coils & other new electrical parts available.
Glen at 806-295-3682 or 806-240-1420 texasmagneto@gmail.com

Re: Magneto Resource

Posted: Sun Jan 26, 2014 1:59 am
by railroad bob
This is a link to ads to sell mags, from the same guy...

http://www.sa200.org/ads/list/13