The Chopper Compendium

Great recycling you are very resourceful.

Thanks!

Igot the headlight and tail light made.

Made from a 50 watt fog light for a car from walmart for 20$ and a trailer light from tractor supplu for 10$

Tail light
http://www.tractorsupply.com/en/store/b ... t-only-red

Head light
http://www.walmart.com/ip/16680057?wmls ... 90&veh=sem

The stock low beam was 50 watt halogen already so plug and play.

I like what Ya did with the Gauges.You plan to seal up the backs?

Silicone?

I got the tail light and licence plate mounted.

Got the headlight mounted.

I have made my handle bars 15 times now.

Hope to find something soon I will like.

Made the slugs for the bars to size down to the stock handle bar size.

Also redid my headlight mount.

I got my handlebars done.

Not exactly what I wanted.

But, I wanted a good rider position not leaning forward and sitting upright to ride it comfortably.

Just a thought , If you are going to put any real mileage on that creation you might consider a "stone deflector" grill on that radiator ! Good lookin' build , bet it looks better in paint !!

Thanks!

It has a deflector on it now the factory one from kawasaki?

I was able to push the bike out for pics now that I got the handlebars.

Sorry for all the pics but, I am pretty Happy especially since I bought the bike 2 months ago yesterday on 5/23/14.

I also got my new chain, Por 15 tank liner to stop it rusting while new inside, and my sealed battey will be here tomorrow. Hope this one fits try #2 but, this one catalogs for a direct replacement/upgrade for the ex500 so should fit.

I got some work on front mount caliper and remake the front wheel axle spacers to remove the speedo parts and wire her.

Had to take some pics of the two bikes together.

nice

Thanks!

I got my handle bars finished.

All the cables for throttle, clutch, and choke.

Mounted the coils.

Mounted the key switch.