The Chopper Compendium

I am moving my shop in new directions. I am moving from one-off design anything frames to a set production style. I will have the tire width built for a 140, 200, or 250. I will build a chopper frame 2, 4, or 6 up, 2 or 4 out. the prostreet style 0,2, or 4 up and 4 or 6 out. all the frames will have the same seat height oil tank motor mounts trans mount and battery location. I think i will only do hardtails. I will only do 35, 38, and 40* rake. I will be changing my frame jig over to a production setup with an adjustable neck setup and that is about it. Basically the jig will look something like this.

Good business move! Is that the frame you are producing? I'ld like to know the story of the formed metal componants.