jigs for drill press
-
krymis
- Conventioneer
- Posts: 277
- Joined: Sun Nov 06, 2011 12:46 pm
- SELF INTRODUCTION: Hey dan it chris (krymis) from the CBH board. thanks for opening this back up. hope to have a project to show the build here. BLAH BLAH BLAH BLAH BLAH and so on and so forth. The book of revolations and worlds ends and shit like that.....
jigs for drill press
these are some of the pics from Scum's build from the old board. these pics show how he overcame the limited tools and built a bitchin chopper.
-
jimmib
- Lurker
- Posts: 91
- Joined: Tue Oct 25, 2011 1:35 pm
- SELF INTRODUCTION: Hello everyone. first of all a big thanks to "Dan the Man". Some of you know me from the previous (2) boards and some don't, so here goes. I have been a fabricator/welder for over 40 years now. Damn that's a helluva long time to do anything! Anyways, I have built literaly 100's of street rods, pro streeters, racecars, bikes and trikes over the years. Never made the headlines and never will. I do what I do because it is the love of my life.
I enjoy reading the posts on the forum and try to contribute when I can. I am sure that this will be every bit as good as the CBH forum, as we will have most of the same folks. Good luck and post a lot of pics!! Jim - Location: Lowcountry USA
Re: jigs for drill press
Now, that middle one shows some ingenuity. It's great when people think out of the box to overcome obstacles.
Whoa!...Musta stood up too fast...
Ever stop to think and forget to start again?
An optomist is no more than a pessimist with an idea.
Gun control is hitting what you are aiming at.....
Ever stop to think and forget to start again?
An optomist is no more than a pessimist with an idea.
Gun control is hitting what you are aiming at.....