Page 1 of 1
newest fixture table
Posted: Mon Mar 12, 2012 8:43 am
by krymis
Its an NRC table. Its got 1/4x20 threaded holes on 1.5" centers. Its 1.5 ton and has pneumatic cylinders for tilting and leveling up to a 45* angle. can't wait to make the new fixtures for it.
Re: newest fixture table
Posted: Mon Mar 12, 2012 8:45 am
by krymis
here is the mill that will make the new frontend parts and the new frame parts. Really looking forward to using them all. Also here is the industrial homemade beadroller.
Re: newest fixture table
Posted: Mon Mar 12, 2012 8:49 am
by curt
nice those tables are crazy expensive
Re: newest fixture table
Posted: Tue Mar 13, 2012 9:26 pm
by jbfrmca
nice over/under mill.
Re: newest fixture table
Posted: Wed Mar 14, 2012 4:26 am
by railroad bob
Nice equipment. Is the mill 3 phase, or single?
Re: newest fixture table
Posted: Wed Mar 14, 2012 8:43 am
by krymis
3 phase 230V older bridgeport.
Re: newest fixture table
Posted: Wed Mar 14, 2012 8:45 am
by krymis
johnnyb i figure this will get used 4 or 5 time and then sold again as usual. its awesome to think of the possibilities of what this can help build to a nice tolerance.