Some flames

This section is for all posts concerning sheet metal fabrication
Post Reply
Brandundee
NewB
Posts: 8
Joined: Thu Jan 31, 2019 6:54 pm
SELF INTRODUCTION: Desk Jockey and paper cut survivor. I know my way around a Manuel Lathe/Mill & Grinders just a little. Also know a little Autocad and Solidworks.

Current Bike- 91 FXR

Previous Bikes- Cone Shovel Chopper, IH Chopper

Project- 57' Straight Leg

Some flames

Post by Brandundee »

IMG_0446.jpeg
IMG_0446.jpeg (493.48 KiB) Viewed 18255 times
Some Flames I did not too long ago
Top
User avatar
railroad bob
Contributor
Posts: 986
Joined: Fri Nov 04, 2011 10:07 pm
SELF INTRODUCTION: Hi Dan, thanks for your time and energy spent on this new board. I hope you will give me a waiver on the email account, I have used gmail so long I don't have a clue what my service provider account is.
I just returned home from a 2 week trip in New Mexico, have a few good pix, can't wait to share my off-highway traveling. Got to put 1400 miles on the scoot.

Best, Bob Davidson
Location: Alaska

Re: Some flames

Post by railroad bob »

That's different. I like it. Gonna smooth it with bondo?
Alaska - Land of the Individual and Other Endangered Species
An Armed Society is a Polite Society,...
Politicians Prefer Unarmed Peasants
TANSTAAFL
Top
Post Reply

Return to “Sheet Metal Work”