Belt settings on Atlas lathe
-
Jeff L
- Contributor
- Posts: 696
- Joined: Fri Oct 28, 2011 5:09 pm
- SELF INTRODUCTION: Hey...I live in South Jersey (the Super Fund State) work as an Operating Engineer local825.Besides bikes I love to fish the surf.I have my current & seemingly endless project a BSA 750 Rocket3, a 72 Honda CB750,79 Kawasaki KZ1000, 48 Simplex, & a 62 Norton Atlas engine
- Location: South Jersey
Belt settings on Atlas lathe
Looking for a chart that shows RPM for given belt settings on an Atlas TH54
Changing the shape of the Earth...1 bucket at a time...IUOE local 825 top of the food chain
-
Dusty-Dave
- Builder
- Posts: 311
- Joined: Sun Dec 01, 2013 4:43 pm
- SELF INTRODUCTION: Hi,
Been building and riding since the 60s. My last contest build made The Horse BC last year "Home Built Indian" and had a 40 Indian in the TCU section of the Horse BC the year before.
Iv'e answered to Dusty since 69
Thanks
Dusty - Location: northern New Mexico
Re: Belt settings on Atlas lathe
Try over on the Yahoo Atlas_Craftsman Metal Working Machines Forum It's probably already in the archive. All the charts and repair procedures I needed for my Craftsman 101-28910 were there
Dusty
Dusty
Molly went to Arkansas, she got raped by Dobbin's dog
But she was doing good 'til she went in the woods
And got pinned up against a log
Pretty good, not bad, she can't complain
'Cause actually all them dogs are just about the same
But she was doing good 'til she went in the woods
And got pinned up against a log
Pretty good, not bad, she can't complain
'Cause actually all them dogs are just about the same