The swingarm axle plates were cast steel. At least they tested that way with the spark test. Instead off taking a chance with the cast material I decided to just remake with steel.
I need to adjust from the rear with how this frame will be so they a almost perfect just need to be the right material.
This angle was the exact same thickness. Cut the back plates from it.
Fly cut square.
Milled slot it has better tolerance than stock plates.
Milled the bolt adjuster stop.
Cut to shape.
Welded and ground
Showing the bushing pressed in my jig for smaller axle.
Plates
Alighnment
Maybe next week with frame rails?